@prefix pubblicazioni: . @prefix unitaDiPersonaleInterno: . @prefix prodotto: . unitaDiPersonaleInterno:MATRICOLA9671 pubblicazioni:autoreCNRDi prodotto:ID22064 . @prefix prodottidellaricerca: . @prefix istituto: . istituto:CDS031 prodottidellaricerca:prodotto prodotto:ID22064 . unitaDiPersonaleInterno:MATRICOLA12158 pubblicazioni:autoreCNRDi prodotto:ID22064 . unitaDiPersonaleInterno:MATRICOLA39012 pubblicazioni:autoreCNRDi prodotto:ID22064 . @prefix modulo: . modulo:ID1948 prodottidellaricerca:prodotto prodotto:ID22064 . @prefix rdf: . @prefix retescientifica: . prodotto:ID22064 rdf:type retescientifica:ProdottoDellaRicerca , prodotto:TIPO1101 . @prefix rdfs: . prodotto:ID22064 rdfs:label "Analysis of creep curves of a nickel base superalloy in a wide stress/temperature range (Articolo in rivista)"@en . @prefix xsd: . prodotto:ID22064 pubblicazioni:anno "2007-01-01T00:00:00+01:00"^^xsd:gYear ; pubblicazioni:doi "10.1016/j.msea.2005.11.084"^^xsd:string . @prefix skos: . prodotto:ID22064 skos:altLabel "
Maldini M., Angella G., Lupinc V. (2007)
Analysis of creep curves of a nickel base superalloy in a wide stress/temperature range
in Materials science & engineering. A, Structural materials: properties, microstructure and processing
"^^rdf:HTML ; pubblicazioni:autori "Maldini M., Angella G., Lupinc V."^^xsd:string ; pubblicazioni:paginaInizio "436"^^xsd:string ; pubblicazioni:paginaFine "440"^^xsd:string ; pubblicazioni:numeroVolume "462"^^xsd:string . @prefix ns11: . prodotto:ID22064 pubblicazioni:rivista ns11:ID496969 ; skos:note "ISI Web of Science (WOS)"^^xsd:string ; pubblicazioni:affiliazioni "CNR-IENI"^^xsd:string ; pubblicazioni:titolo "Analysis of creep curves of a nickel base superalloy in a wide stress/temperature range"^^xsd:string ; prodottidellaricerca:abstract "The creep behaviour of the nickel base superalloy Nimonic 263 has been studied at constant load and temperature in the 750-30 MPa/600-950 degrees C range. The experimental results have shown a very strong dependence of the creep curve shape with the applied stress/temperature. At high stresses, when an instantaneous plastic strain occurs during the initial loading, the creep curves are charac terised by an important decelerating/primary creep while, at lower applied stresses, the primary stage becomes very short and small and other strain stages dominate the creep curves. The experimental results can be rationalised supposing that the mobile dislocation density decreases/increases during creep, from an initially high/low value in the tests run above/below the alloy yield stress. With this hypothesis, the creep results have been modelled using coupled differential equations of the Kachanov form. (C) 2006 Elsevier B.V. All rights reserved."@en ; prodottidellaricerca:prodottoDi modulo:ID1948 , istituto:CDS031 ; pubblicazioni:autoreCNR unitaDiPersonaleInterno:MATRICOLA39012 , unitaDiPersonaleInterno:MATRICOLA12158 , unitaDiPersonaleInterno:MATRICOLA9671 . @prefix parolechiave: . prodotto:ID22064 parolechiave:insiemeDiParoleChiave . ns11:ID496969 pubblicazioni:rivistaDi prodotto:ID22064 . parolechiave:insiemeDiParoleChiaveDi prodotto:ID22064 .